Adapter: Matsushita Male to 9006 Female

Dead Ballast: If you've got a ballast out on your Nissan, Infiniti, Acura, or Honda; buying a new OEM replacement certainly is not cheap! Custom Setup: If you're doing a quad retrofit on a vehicle with factory HID headlights, these will allow you to run a splitter and relay harness off the factory ballast wiring without any splicing. No Matter What: We're asking ourselves why we didn't make these sooner! These convenient adapters allow the use of aftermarket parts in place of expensive Original-Equipment ballasts with zero cutting, splicing, or re-wiring involved. Quality: Made with stranded copper wire, fully sealed male and female connections, and protected with tech-flex mesh in between; these adapters should last longer than your original ballasts did! Compatibility: Available to fit the OE-side connector on most modern Nissan, Infiniti's, Acura's, and Hondas that use Panasonic/Matsushita Gen III or IV ballasts, or Mitsubishi Electric Gen II or III Ballasts.

Technical Specifications

• WIRE THICKNESS: 14 AWG
• LENGTH: Approx. 6in / 150mm
• INSULATION: Braided TechFlex
• Connector 1: OE Matsushita Male
• Connector 2: 9006 Female

What's Included

• Wiring Adapter: 1x Matsushita Male to 9006 Female Adapter
• Warranty: 2 Years

Compatibility

• INPUT TYPE: OE Matsushita Male (Same as Matsushita Ballast Input)
• OUTPUT TYPE: 9006 Female

Manufacturer Part Number

• H670